Marmolium Floors – Floor Finish application

1. If floor has been stripped, ensure floor has been neutralized and clear water rinsed properly prior to finish application procedures. If floor has been scrubbed using ‘Cleaner & Conditioner’, neutralizing is not necessary, however, a clear water rinse is required. Check pH of floor.
2. Assemble all equipment, cleaning and custodial hardware prior to beginning procedures. Read safety instructions on MSDSs and chemical product labels and comply as directed.
3. Place Wet Floor Signs at access area(s) to foot traffic.
4. Pour Ultra Floor Care floor finish in a bucket with wringer lined with a plastic bag. Immerse clean, pre-broken in, lint free, dedicated floor finish mop fully in finish. Wring out bottom half of mop.
5. Apply your choice of an Ultra Floor Care floor finish. Apply 5 or 6 medium coats depending upon porosity of floor, desired appearance, traffic conditions, etc. Flex Gold – apply 4 coats to floor and burnish. Then apply 2 further coats and burnish. Flex Platinum – apply 3 coats to floor and burnish then apply a final coat and burnish.
6. Ultra Floor Care floor finishes may be blended in perfectly with previous coats if recommended maintenance procedures have been preformed. If this is a re-coat after scrubbing (not stripping), or in an area where the coating is to be blended in, apply coats directly on the affected area(s).

Posted in: Floor care, Stripping & Recoating

Languages

Please visit our affiliate site in Japanese

Newsletter Sign-up