Procedures for Extraction with truck Mount Extraction Equipment

1. Thoroughly vacuum the carpets to remove lose soil particles.
2. Wherever other chemicals have been used you must thoroughly flush the full system equipment before using Ultra products.
3. Mix Clean at 64 ml per liter (8 oz per gallon) of water in a pump up sprayer. Add Neutralizer to the solution at 8 ml per liter (1 oz per gallon). 16 ml per liter (2 oz per gallon) for carpet that is heavily soiled.
4. Pre-spray the area to be extracted. Limit the pre-sprayed area to the area that can be extracted in about 15 minutes time.
5. Add Liquid Extract to the extractor solution tank at 8 ml per liter (1 oz per gallon) of water. Add the solution to the required amount of warm water in the chemical feeder tank. If the carpet is extremely soiled, add Neutralizer at 8 ml per liter (1 oz per gallon). (If powder Extract is used, pre-mix in warm water 16 ml per liter (2 oz per gallon) (4 liters) of water metered at the wand.)
6. Begin extraction of the pre-sprayed area after 5 minutes dwell time. The total pre-sprayed area should be extracted before 15 minutes have elapsed.

Alternate Procedure Options
Special Note: Extract should be used with warm water to enhance the optimum use of the fabric softeners within the formula. Warm water enhances the cleaning ability of the chemical and will also promote faster drying time of the carpet.

Quantity of Chemicals may be reduced after 3 cleanings with Ultra Chem Products. See directions for details.

Posted in: Cleaning

Languages

Please visit our affiliate site in Japanese

Newsletter Sign-up